User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A
User’s Manual of LRP-422CST
4.4.5 LACP Port Setting
This page is used to configure the LACP port setting. The LACP Port Setting screens in Figure 4-4-10 & Figure 4-4-11 appear.
Figure 4-4-10 LACP Port Setting Page Screenshot
The page includes the following fields:
Object Description
Port Select
Select port number from this drop-down list to set LACP port setting.
Priority
The Priority controls the priority of the port. If the LACP partner wants to form a
larger group than is supported by this device, then this parameter will control
which ports will be active and which ports will be in a backup role.
Lower number means greater priority.
Timeout
The Timeout controls the period between BPDU transmissions. Short will
transmit LACP packets each second, while Long will wait for 30 seconds before
sending an LACP packet.
Buttons
: Click to apply changes.
Figure 4-4-11 LACP Port Information Page Screenshot
The page includes the following fields:
11
8