User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A
User’s Manual of LRP-422CST
4.3.7 Port Error Disabled Configuration
This page provides to set port error disable function. The Port Error Disable Configuration screens in Figure 4-3-13 & Figure
4-3-14 appear.
Figure 4-3-13 Error Disabled Recovery Page Screenshot
The page includes the following fields:
Object Description
Recovery Interval The period (in seconds) for which a port will be kept disabled in the event of a port
error is detected (and the port action shuts down the port).
BPDU Guard Enable or disable the port error disabled function to check status by BPDU guard.
Self Loop Enable or disable the port error disabled function to check status by self loop.
Broadcast Flood Enable or disable the port error disabled function to check status by broadcast
flood.
Unknown Multicast
Flood
Enable or disable the port error disabled function to check status by unknown
multicast flood.
Unicast Flood Enable or disable the port error disabled function to check status by unicast flood.
ACL Enable or disable the port error disabled function to check status by ACL.
Port Security
Violation
Enable or disable the port error disabled function to check status by port security
violation.
DHCP Rate Limit Enable or disable the port error disabled function to check status by DHCP rate
limit
ARP Rate Limit Enable or disable the port error disabled function to check status by ARP rate limit
102