User Manual

23
Type 2: LRP-201HT with 48~54V power adapter and LRP-201ET with PoE power
output
LRP-201ET
Long Reach PoE Extender
Cat. 5e/6
PoE IP Camera
LRP-201HT
Long Reach PoE Injector
P1 P2 FAULT
PAIR
SYS
BNC
LRP Out
RJ45
PoE 30W 60W+
PoE Input
LRP-201HT
Injector
LNK/ACT
10/100/1000T
PoE In
Ethernet Switch
802.3bt PoE
Cat. 5e/6
PWR
PAIR
SYS
BNC
LRP In
RJ45
LNK/ACT
PoE-in-Use
10/100/1000T
LRP-201ET
Extender
PoE
AC-to-DC Adapter
75W/48~54V DC IN
110-240V AC
Power over UTP
Functions
LRP Injector LRP Extender
LRP-201HT LRP-201ET
Power Input
Power adapter with 48~54V
DC in
UTP with DC power over UTP
input
Power Output
UTP with DC power over UTP
output
RJ45 with 802.3at/bt PoE
output
Installation Instructions
Step 1: Remove the “Danger No Ethernet” labels stuck on the RJ45 LRP ports of
LRP-201HT and LRP-201ET.
Step 2: Connect the LRP Injector (LRP-201HT) and LRP Extender (LRP-201ET) to
ends of RJ45 long UTP/telephone wire.
Warning
1. Please do not connect any Ethernet device to LRP OUT Port of the
LRP-201HT; otherwise, it will damage the Ethernet device.
2. Please do not connect any Ethernet device to LRP IN Port of the
LRP-201ET; otherwise, it will damage the Ethernet device.
Step 3: Connect Cat. 5e/6 UTP cable to LRP-201HT and non-PoE switch or
workstation.
Step 4: Connect 48~54V DC power adapter to LRP-201HT power socket, and then
the PWR LED of LRP-201HT and LRP-201ET should light up immediately.
Step 5: Connect Cat. 5e/6 UTP cable to LRP-201ET and IEEE 802.3at/bt complied
PoE IP camera or PoE Wireless AP.