User Manual

22
Installation Instructions
Step 1: Remove the “Danger – No Ethernet” labels stuck on the RJ45 LRP port
of LRP-201HT and LRP-201ET.
Step 2: Connect the LRP Injector (LRP-201HT) and LRP Extender (LRP-201ET) to
ends of RJ45 terminated long UTP/telephone wire cable.
Warning
1. Please do not connect any Ethernet device to LRP OUT Port of the
LRP-201HT; otherwise, it will damage the Ethernet device.
2. Please do not connect any Ethernet device to LRP IN Port of the
LRP-201ET; otherwise, it will damage the Ethernet device.
Step 3: Connect Cat. 5e/6 UTP cable to LRP-201HT and IEEE 802.3bt compliant
PoE Switch or PoE Injector. If the PoE switch or PoE injector is powered on
already, then the PWR LED of LRP-201HT and LRP-201ET should light up
accordingly.
Step 4: Connect Cat. 5e/6 UTP cable to LRP-201ET and IEEE 802.3at/bt complied
PoE IP camera or PoE wireless AP.
Warning
The LRP-201HT accepts IEEE 802.3bt equipment for optimal power
injection. The other non-standard PoE Power devices may cause the
LRP-201HT to malfunction.
Note
1. Before installation, please consider the distance and watts value
demand for PD devices. The LRP-201-KIT PoE output capacity
and upload / download performance depend on the length of UTP
cable.
2. As there are various resistance values in the UTP/telephone wire,
the actual data rate will vary on the quality of the copper wire and
environmental factors.