User Manual

User’s Manual of LRP-822CS/LRP-1622CS
81
The page includes the following fields:
Object Description
 Port Select
Select port number from this drop-down list.
 Enabled
Indicates the port state operation. Possible states are:
Enabled - Start up the port manually.
Disabled – Shut down the port manually.
 Speed
Select any available link speed for the given switch port. Draw the menu bar to
select the mode.
 Auto - Setup Auto negotiation.
 Auto-10M - Setup 10M Auto negotiation.
 Auto-100M - Setup 100M Auto negotiation.
 Auto-1000M - Setup 1000M Auto negotiation.
 Auto-10/100M - Setup 10/100M Auto negotiation.
 10M - Setup 10M Force mode.
 100M - Setup 100M Force mode.
 1000M - Setup 1000M Force mode.

Select any available link duplex for the given switch port. Draw the menu bar to
selec
Duplex
t the mode.
 otiation. Auto - Setup Auto neg
 Full - Force sets Full-Duplex mode.
 ex mode. Half - Force sets Half-Dupl
 Flow Control
When section indicates the flow control
capability that is advertised to the link partner. When a fixed-speed setting is
selected, that is what is used. Current Rx column indicates whether pause
frames on the port are obeyed. Current Tx column indicates whether pause
ation. Check the configured column to use flow
r Configured Link Speed.
Auto Speed is selected for a port, this
frames on the port are transmitted. The Rx and Tx settings are determined by the
result of the last Auto-Negoti
control. This setting is related to the setting fo
Buttons
: Click to apply changes.