User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A
- EC Declaration of Conformity
User’s Manual of LRP-822CS/LRP-1622CS
48
The page includes the following fields:
Object Description
Save Configuration to
FLASH
Click to save the configuration. For more detailed information, please refer to
chapter 4.1.2
Restore to Default
Click to reset switch in default parameter. For more detailed information, please
refer to chapter 4.15.1
4.1.2 Configuration Manager
The system file folder contains configuration settings. The screen in Figure 4-1-7 appears.
Figure 4-1-7 Save Button Screenshot
The page includes the following fields:
Object Description
Running Configuration
Refers to the running configuration sequence use in the switch. In switch, the
n file stores in the RAM. In the current version, the running
configuration sequence running-config can be saved from the RAM to FLASH by
Source File = Running Configuration” to “Destination File = Startup
Configuration”, so that the running configuration sequence becomes the startup
uration file, which is called configuration save. To prevent illicit file upload
and easier configuration, switch mandates the name of running configuration file
to be running-config.
running configuratio
saving “
config
Startup Configuration
Refers to the configuration sequence used in switch startup. Startup
configuration file stores in nonvolatile storage, corresponding to the so-called
configuration save. If the device supports multi-config file, name the configuration
file to be .cfg file, the default is startup.cfg. If the device does not support
multi-config file, mandates the name of startup configuration file to be
startup-config.
Backup Configuration
The backup configuration is empty in FLASH; please save the backup
confi nager”. guration first by “Maintenance > Backup Ma