User Manual

Table Of Contents
User’s Manual of LRP-822CS/LRP-1622CS
Step 5: Supply power to the LRP Managed Switch.
Connect one end of the power cable to the LRP Managed Switch. Connect the power plug of the power cable to a
standard wall outlet. When the LRP Managed Switch receives power, the Power LED should remain solid Green.
2.2.2 Rack Mounting
To install the LRP Managed Switch in a 19-inch standard rack, please follow the instructions described below.
Step 1: Place the LRP Managed Switch on a hard flat surface, with the front panel positioned towards the front side.
Step 2: Attach the rack-mount bracket to each side of the LRP Managed Switch with supplied screws attached to the package.
Figure 2-1-5 shows how to attach brackets to one side of the LRP Managed Switch.
Figure 2-1-5 Attach Brackets to the LRP Managed Switch.
You must use the screws supplied with the mounting brackets. Damage caused to the parts by
using incorrect screws would invalidate the warranty.
Step 3: Secure the brackets tightly.
Step 4: Follow the same steps to attach the second bracket to the opposite side.
Step 5: After the brackets are attached to the LRP Managed Switch, use suitable screws to securely attach the brackets to the
rack, as shown in Figure 2-1-6.
29