User Manual

User’s Manual of LRP-822CS/LRP-1622CS
149
The page includes the following fields:
Object Description
 STP
Display the current STP state
 BPDU Forward
Display the current BPDU forward mode
 Cost Method
Display the current cost method
 Force Version
Display the current force version
 Configuration Name
Display the current configuration name
 Configuration Revision
Display the current configuration revision
4.6.3 STP Port Setting
u to configure per port S 6-7 appear. This page allows yo TP settings. The STP Port Setting screens in Figure 4-6-6 & Figure 4-
ig
The page includes the following fields:
F ure 4-6-6 STP Port Configuration Page Screenshot
Object Description
 Port Select
Select port number from this drop-down list.
 E
Auto)
Controls the path cost incurred by the port. The Auto setting will set the path cost
as appropriate by the physical link speed, using the 802.1D recommended
values. Using the Specific setting, a user-defined value can be entered. The path
cost is used when establishing the active topology of the network. Lower path
cost ports are chosen as forwarding ports in favor of higher path cost ports. Valid
values are in the range 1 to 200000000.
xternal Cost (0 =
 Edge Port
Controls whether the operEdge flag should start as being set or cleared. (The
initial operEdge state when a port is initialized).
 BPDU Filter
Control whether a port explicitly configured as Edge will transmit and receive
BPDUs.