User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A
- EC Declaration of Conformity
User’s Manual of LRP-822CS/LRP-1622CS
107
transmitted. The RX and TX settings are determined by
gotiation. Check the configured column to use flow
to the setting for Configured Link Speed.
frames on the port are
the result of the last Auto-Ne
control. This setting is related
Buttons
: Click to apply changes.
Figure 4-4-7 LAG Port Status Page Screenshot
The page includes the following fields:
Object Description
LAG
The LAG for the settings contained in the same row
Description
rrent description Display the cu
Port Type
Display the current port type
Enable State
Display the current enable state
Speed
Display the current speed
Duplex
Display the current duplex mode
Flow Control Config
Display the current flow control configuration
Flow Control Status
w control status Display the current flo
LACP is available for GE1~ E4. G