User Manual

User’s Manual of LRP-822CS/LRP-1622CS
106
Displ
ay the link state
 Link State
 Active Member
Display the active member
 Standby Member
Display the standby member
 Modify
Click
to modify LAG configuration
4.4.3 LAG Port Setting
This page allows setting configuration for each LAG. The LAG Port Setting screens in Figure 4-4-6 & Figure 4-4-7 appear.
Figur
The page includes the following fields:
e 4-4-6 LAG Port Setting Information Page Screenshot
Object Description
 LAG Select
Select LAG number from this drop-down list.
 Enable
Indicates the LAG state operation. Possible states are:
Enabled - Start up the LAG manually.
Disabled – Shut down the LAG manually.
 Speed
Select any available link speed for the given switch port. Draw the menu bar to
select the mode.
 Auto – Set up Auto negotiation.
 Auto-10M – Set up 10M Auto negotiation.
 Auto-100M – Set up 100M Auto negotiation.
 Auto-1000M - Set up 1000M Auto negotiation.
 Auto-10/100M – Set up 10/100M Auto negotiation.
 10M – Set up 10M Force mode.
 100M – Set up 100M Force mode.
 1000M – Set up 1000M Force mode.
 ontrol
When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner. When a fixed-speed setting is
The current RX column indicates whether pause
eyed. The current TX column indicates whether pause
Flow C
selected, that is what is used.
frames on the port are ob