User's Manual

15
5. Applications
The EoC Converter does not require any software conguration. Users can
immediately use any feature of this product simply by attaching the cables and
turning the power on. There are some key limitations on the EoC Converter.
Please check the following items.
5.1 Point-to-Point Application -- LAN to LAN Connection
One set of the EoC Converter could be used to link two local area networks
that are located in dierent places. Through the coaxial cable, it could set up
a 100Mbps backbone, but one EoC Converter must be Master (CO mode) and
the other one is Slave (CPE mode).
Point to Point Application
Up to 2000m
Ethernet over Coaxial
5V DC adapter
Switch
PC
LRE-101C
Master
LRE-101C
Slave
5V DC adapter
Connecting Standalone PC
Refer to the following procedures to set up the LRE-101C LAN to LAN
connection.
1. [LAN1] Set the LRE-101C in LAN 1 to be in the Master mode from the DIP
switch.
2. [LAN2] Set the LRE-101C in LAN 2 to be in the Slave mode from the DIP
switch.
3. Power on the LRE-101C Master and Slave at both sides by connecting its
power source.
4. Master or Slave LED will illuminate correspondingly.
5. Connect coaxial cable from LAN1 LRE-101C to BNC port of the LAN2
LRE-101C.
6. LNK LED will blink to illuminate at both LRE-101C units.
7. Connect the LRE-101C Ethernet LAN port to other network device via
regular Cat5e UTP cable.