User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Introduction
- Chapter 3. Preparation
- Chapter 4. Web-based Management
- Appendix A: DDNS Application
Industrial LoRaWAN Gateway
LCG-300 series
- 53 -
4.4.9 Fault Alarm
This page provides fault alarm setting as shown in Figure 4-4-25.
Figure 4-4-25: Fault Alarm
Object Description
• Enable
Controls whether Fault Alarm is enabled.
• Record
Controls whether Record is sending System log or SMS.
• Event
Detects there is Port Failure or Power Failure, or both.
• Power Alarm
Detects PWR1 or PWR2 is at fault, or both.
• Port Alarm
Detects which Port or all is or are at fault.