User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Introduction
- Chapter 3. Preparation
- Chapter 4. Web-based Management
- Appendix A: DDNS Application
Industrial LoRaWAN Gateway
LCG-300 series
- 39 -
Step 3: WAN Interface
The LoRaWAN Gateway supports two access modes on the WAN side shown in Figure 4-4-5 and
Figure 4-4-6
Figure 4-4-5: Setup Wizard – WAN 1 Configuration
Figure 4-4-6: Setup Wizard – WAN Configuration
Mode 1 -- Static IP
Select Static IP Address if all the Internet port’s IP information is provided to you by your ISP. You will
need to enter the IP Address, Netmask, Default Gateway and DNS Server provided to you by your
ISP. Each IP address entered in the fields must be in the appropriate IP form, which are four octets
separated by a dot (x.x.x.x). The LoRaWAN Gateway will not accept the IP address if it is not in this
format. The setup is shown in Figure 4-4-7.