Quick Guide

8
3.4 5G NR Antenna Installation (For LCG-300-NR Only)
Step 1: Connect 5G NR antennas to the 5G NR antenna extender.
Step 2: Fasten the 5G NR antenna extenders to the connectors.
3.5 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of LoRaWAN Gateway
is used for two DC redundant power inputs. Please follow the steps below to
insert the power wire.
When performing any of the procedures like inserting the wires
or tightening the wire-clamp screws, make sure the power is
OFF to prevent from getting an electric shock.
1. Insert positive and negative DC power wires into contacts 1 and 2 for
POWER 1, or 5 and 6 for POWER 2.
Max. Fault Alarm Loading: 24V, 1A
DI1 DO0 DO1DI0 GNDGND
V1+ V2+
PWR1
PWR2Alarm
DC Input: 9-54V , 1.3A max.
AC Input: 24V
, 0.5A max.
1 2 3 4 5 6
1 2 3 4 5 6
LCG-300/LCG-300W