User Manual

15
Step 2: Place the wall-mount plate on the rear panel of the Industrial
Media Converter.
Step 3: Use the screws to screw the wall-mount plate on the
Industrial Media Converter.
Step 4: Use the hook holes at the corners of the wall-mount plate to
hang the Industrial Media Converter on the wall.
Step 5: To remove the wall-mount plate, reverse the steps above.
3.3 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of Industrial
Media Converter is used for two DC redundant power inputs. Please
follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into Contacts 1 and 2 for
power 1 or 5 and 6 for power 2.
Input
DC12~48V, AC 24V
V1+ 1A@24VV1-
V1+ V1-
DC1
V2+ V2-
V2+ V2-
DC2Fault
1 2 3 4 5 6