User's Manual

Industrial VPN Security Gateway
IVR-100_IVR-300 Series
- 42 -
Chapter 4. Web-based Management
This chapter provides setup details of the device’s Web-based Interface.
4.1 Introduction
The device can be configured with your Web browser. Before configuring, please make sure your PC is under
the same IP segment with the device.
4.2 Logging in to the VPN Gateway
Refer to the steps below to configure the VPN Gateway:
Step 1. Connect the IT administrator’s PC and VPN Gateway’s LAN port (port 1) to the same hub / switch,
and then launch a browser to link the management interface address which is set to
http://192.168.1.1 by default.
The DHCP server of the VPN Gateway is enabled. Therefore, the LAN PC will
get IP from the VPN Gateway. If user needs to set IP address of LAN PC
manually, please set the IP address within the range between 192.168.1.2 and
192.168.1.254 inclusively, and assigned the subnet mask of 255.255.255.0.
Step 2. The browser prompts you for the login credentials. (Both are “admin” by default.)
Default IP address: 192.168.1.1
Default user name: admin
Default password: admin
Default 2.4GHz SSID: PLANET_2.4G (for IVR-300W)
Default 5GHz SSID: PLANET_5G (for IVR-300W)
Administrators are strongly suggested to change the default admin and
password to ensure system security.