User's Manual

Industrial VPN Security Gateway
IVR-100_IVR-300 Series
- 29 -
Step 3: Connect your device to hub / switch.
A. Connect one end of a standard network cable to the LAN port (port 1) of the device.
B. Connect the other end of the cable to the hub / switch.
The UTP Category 5, 5e or 6 network cabling with RJ45 tips is recommended.
Step 4: Connect your device to internet.
A. Connect one end of a standard network cable to the WAN port (port 5) of the device.
B. Connect the other end of the cable to the LAN port of ISP network device (such as a modem).
If there is only one line connected to the outer network in your network environment, it is
suggested that you use WAN port (port 5).
Step 5: Power on the device. When the device receives power, the Power LED should remain solid Green.
2.2.2 Wall Mount Plate Mounting
To install the Industrial Gateway on the wall, please follow the instructions below.
Step 1: Remove the DIN-rail from the Industrial Gateway. Use the screwdriver to loosen the screws to remove
the DIN-rail.
Step 2: Place the wall-mount plate on the rear panel and use the screwdriver to screw the wall mount plate
tightly on the Industrial Gateway.