User Manual

Step 4: Power on the Industrial Fast Ethernet Switch. (Please refer

to the Wiring the Power Inputs section for power input) The

power LED on the Industrial Fast Ethernet Switch will light

up. Please refer to the LED Indicators section for meaning of

LED lights.

Step 5: Prepare the twisted-pair, straight through Category 5 cable

for Ethernet connection.

Step 6: Insert one side of Category 5 cables into the Industrial Fast

Ethernet Switch Ethernet port (RJ-45 port) and another side

of category 5 cables to the network devices’ Ethernet port

(RJ-45 port), ex: Switch, PC or Server. The UTP port (RJ-45)

LED on the Industrial Fast Ethernet Switch will light up when

the cable connected with the network device. Please refer to

the LED Indicators section for LED light meaning.

Note

Be sure the connected network devices support MDI/

MDI-X. If the network devices do not support MDI/MDI-

X, please use the crossover category 5 Cable to connect.

Step 7: Insert ber cable from the ISW-511 / 621 series or ISW-

511T / ISW-621T series to the ber network. TX, RX must

be paired at both ends. The optical port LED on the Industrial

Fast Ethernet Switch will light up when the cable connected

with network device. Please refer to the LED Indicators

section for LED light meaning.

Step 8: When all connections are set and the LEDs are light without

any issue mean that the installation is complete.