User's Manual

ManualsBrandsPLANET Technology ManualsDIN-rail Unmanaged Ethernet Switches5-Port 10/100TX Industrial Fast Ethernet Switch (-40~75 degrees C operating temperature)

- 9 -

- 10 -

- 11 -

- 12 - - 13 - - 14 -

1 2 3 4 5 6

Insert the wires into the fault alarm contacts

Note

1. The wire gauge for the terminal block should

be in the range between 12 ~ 24 AWG.

2. Alarm relay circuit accepts up to 30V, max.

3A currents.

Step 2:LightlypressthebuttonofDIN-Railintothetrack.

Step 3: ChecktheDIN-Railistightlyonthetrack.

Step 4: Please refer to following procedures to remove the

Industrial Fast Ethernet Switch from the track.

6. Mounting Installation

This section describes how to install the Industrial Fast

Ethernet Switch and make connections to it. Please read

the following topics and perform the procedures in the order

being presented.

DIN-Rail Mounting

The DIN-Rail is screwed on the Industrial Fast Ethernet

Switch when out of factory. When need to replace the wall

mount application with DIN-Rail application on Industrial

Fast Ethernet, please refer tofollowinggurestoscrewthe

DIN-RailontheIndustrialFastEthernetSwitch.Tohangthe

Industrial Fast Ethernet Switch, follow the below steps:

Step 1: screw the DIN-Rail on the IndustrialFast Ethernet

Switch.

Step 5: Lightly press the button of DIN-Rail for remove it

from the track.

Wall Mount Plate Mounting

To install the Industrial Fast Ethernet Switch on the wall,

please follows the instructions described below.

Step 1: Remove the DIN-Rail from the Industrial Fast

Ethernet Switch; loose the screws to remove the

DIN-Rail.

Step 2: Place the wall mount plate on the rear panel of

the Industrial Fast Ethernet Switch.

Step 3: Use the screws to screw the wall mount plate on

the Industrial Fast Ethernet Switch.

Step 4: Use the hook holes at the corners of the wall

mount plate to hang the Industrial Fast Ethernet

Switch on the wall.

Step 5: To remove the wall mount plate, reverse steps

above.

7. Customer Support

Thank you for purchase PLANET products. You can browse

our online FAQ resource at the PLANET Web site rst to

check if it could solve you issue. If you need more support

information, please contact PLANET switch support team.

PLANET online FAQ :

http://www.planet.com.tw/en/support/faq.php?type=1

Switch support team mail address :

support_switch@planet.com.tw

Contentssubjecttorevisionwithoutpriornotice.

PLANET is a registered trademark of PLANET Technology

Corp.  All other trademarks belong to their respective

owners.