User's Manual

- 54 -
 In the Dial Rules section by moving the dial rules from the Available Rules field to the Selected Rules field to
enable the dial rules in this dial permission. In the above given example, 2 dial rules had been enabled. The
“Dial-FXO” rule is used to make phone calls through CO lines (land lines). The “dial-sip-trunk” rule is used to
make phone call through the SIP trunk. So if you assign this dial permission to the extension users, they will
be able to make outbound phone call both through CO lines and the SIP trunk.
 In the Internal Permissions section by switching the internal call features on/off to enable/disable the call
features.
 Extension: Allow/Disallow dialing other extension numbers.
 Paging & Intercom: Allow/Disallow dialing paging & intercom group numbers.
 Conference: Allow/Disallow using conference feature.
 Parked Call: Allow/Disallow answering the parked calls.
 DISA: Allow/Disallow using DISA feature.
 Pickup Exten: Allow/Disallow pickup phone calls on other extensions.
 Feature Codes: Allow/Disallow using feature codes.
 Queue: Allow/Disallow dialing the call queue numbers.
 IVR: Allow/Disallow dialing IVR extensions.
 Spy: Allow/Disallow spying on other extensions’ phone calls.
 Audio Console: Allow/Disallow using feature code to broadcast through audio out interface (IPX-2200
and IPX-2500 only).
By default all extensions use the default dial permission “DialPlan1”, if you have created new dial permissions,
please don’t forget to assign them to the extensions from Telephony -> Extensions -> IP Extensions and Telephony
-> Extensions -> Analog Extensions (if there are analog extensions) page.