User's Manual

- 98 -
 In the Server Address field you should specify the OpenVPN server address, which can be a public IP or a
domain name.
 The Port number should be exactly the same as on the OpenVPN server. By default it’s 1194.
 The transport Protocol should be exactly the same as on the OpenVPN server. By default UDP is used.
 Device Node could be set to TUN or TAP, a TAP device is a virtual Ethernet adapter, while a TUN device is a
virtual point-to-point IP link.
 Cipher (or Cypher) is an algorithm for performing encryption or decryption.
 Either to enable Compress LZO or not, depends on if you have enabled it on the server.
 If Default Gateway enabled, it will use VPN connection as default gateway, data which should be sent to the
default gateway will now be sent though VPN connection.
Once done, click on submit to save the configurations. Finally click on Enable switch to switch on the VPN client
connection.
And you may check the VPN connection status in the VPN Client Status section.
In the VPN client status section the VPN client IP, the VPN type and the connection status will be displayed.