User's Manual

- 84 -
The jumpers shown in the picture below are for crossover cables and straight cables to connect a BRI connection.
The jumpers for Port 1, 2 and Port 3, 4 are on different position. Attach the BRI lines to these ports and then
configure BRI parameters.
Type of Port could be set to TE_PTP, TE_PTMP, NT_PTP and NT_PTMP.
 TE_PTP: BRI PTP Point to Point signaling (CPE side)
 TE_PTMP: BRI PTMP Point to Multi-Point signaling (CPE side)
 NT_PTP: BRI PTP Point to Point signaling (Network side)
 NT_PTMP: BRI PTMP Point to Multi-Point signaling (Network side)
For other parameters please configure them according to the instructions of the service provider or ask for advice
from our support team. Otherwise please do not change these settings without professional guidance.