Quick Guide
Table Of Contents
4
1.2 Hardware Installation
The following are instructions for setting up PLANET Internet Telephony PBX
system. Refer to the illustration and follow the simple steps below to quickly install
your Internet Telephony PBX system.
1.2.1 Safety Instructions
The following are the safety instructions for Internet Telephony PBX system before
installing.
The maximum operating temperature of the Internet Telephony PBX system is
0~40°C,whichallowssufcientaircirculation.
The connections and equipment that supply power to the IP PBX should be
capable of operating safely with the maximum power requirements of the IP
PBX. In the event of a power overload, the supply circuits and supply wiring
should become hazardous.
The power adapter must plug into the right supply voltage. Make sure that the
supplied power voltage is correct and stable. If the input power voltage is over
10% lower than the standard, it may cause the IP PBX to malfunction.
Generally, when installed after the nal conguration, the product must comply
with the applicable safety standards and regulatory requirements of the country
in which it is installed. If necessary, consult for technical support.
1.2.2 Placement
Make sure the device is placed in a safe environment to avoid equipment failure.
DO NOT place anything on top of the device. Excessive weight could damage it.
DO NOT obstruct ventilation slots on each side of the IP PBX or expose it to
direct sunlight or other heat sources. Be sure that there is adequate air ow
around the IP PBX.
PlacetheIPPBXonaatsurfacetoavoidanydamage.