User's Manual

- 10 - - 12 - - 13 - - 14 -
- 9 - - 11 -
Step 2: Refer to the picture below to screw the four screws on the wall.
140.36mm
59mm
PoE-
in-Use
PoE+Data
IPOE-165
PWR
DC Input Range:
24-56V , 1.6A max.
V+
PoE-
in-Use
PoE+Data
IPOE-165
PWR
DC Input Range:
24-56V , 1.6A max.
V+
Step 3: Use a screwdriver to screw them into the wall.
3.4 Grounding the Device
Users MUST complete grounding wired with the device; otherwise, a
sudden lightning could cause fatal damage to the device.
Earth Ground
4.ProductSpecications
Product IPOE-165
Hardware Specications
Interface
Input Port
1 x 10/100/1000BASE-T “Data” in RJ45
port
Output Port
1 x 10/100/1000BASE-T Ethernet with
IEEE 802.3at PoE+
“Data + DC” out RJ45 port
Input Power
Terminal Block
1 x 2-pin terminal block
- Pin 1/2 for Power (Pin 1: V+ / Pin 2: V-)
Network Cable
10BASE-T: UTP category 3, 5 cable
(≤100m)
100BASE-TX: UTP category 5,5e cable
(≤100m)
1000BASE-T: UTP category 5e,6
cable(≤100m)
Data Rate 10/100/1000Mbps
LED Indicator
PWR (Green)
PoE-in-use x 1 (Green)
Input Voltage 24~56V DC
Power Consumption
Voltage System on Full Load (Max.)
DC 24V 0.72W 43.4W
DC 36V 0.72W 41.04W
DC 54V 1.08W 40.5W
User’s Manual
www.PLANET.com.tw
PLANET Technology Corp.
2351-AH8080-000
10F., No. 96, Minquan Rd., Xindian Dist., New Taipei City 231, Taiwan
Warning:
This device is compliant with Class A of CISPR 32.
In a residential environment this device may cause radio interference.
材質:100P特銅紙,水性光
尺寸:105x148mm(A6),A3三折單張彩色
Industrial IP67 1-Port 802.3at PoE+ Injector
►
IPOE-165
Standards Conformance
Regulatory Compliance
FCC Part 15 Class A
CE
Stability Testing
IEC 60068-2-32 (Free fall)
IEC 60068-2-27 (Shock)
IEC 60068-2-6 (Vibration)
Standards Conformances
IEEE 802.3 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3ab 1000BASE-T Gigabit
Ethernet
IEEE 802.3af Power over Ethernet
IEEE 802.3at Power over Ethernet Plus
Environment
Operating Temperature -40 ~ 75 degrees C
Storage Temperature -40 ~ 85 degrees C
Humidity 5 ~ 95% (non-condensing)
5. Customer Support
Thank you for purchasing PLANET products. You can browse our online
FAQ resource and user’s manual on PLANET web site rst to check if it
could solve your issue. If you need more support information, please
contact PLANET support team.
PLANET online FAQs:
https://www.planet.com.tw/en/support/faq?method=category&c1=2
Support team mail address:
[e-mail]
Copyright © PLANET Technology Corp. 2020.
Contents are subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology Corp. All other
trademarks belong to their respective owners.
Note
EMD (Lightning) DAMAGE IS NOT CONVERED UNDER
WARRANTY.
3.5 Connecting IPOE-165 to PD
Step 1: Connect the additional Cat5e/6 cable from the PoE+ Out of
the IPOE-165 to a remote PD.
DC
Power Line (DC)
1000BASE-T UTP
PoE
1000BASE-T UTP with PoE
PoE
Power
Data
PoE IP Camera
IPOE-165
Data
100m
802.3at PoE+
Power Supply
Power
DC
DC24-56V
Etherent Switch
Step 2: The PoE+ Out port is the power injector which transmits DC
voltage to the Cat5e/6 cable and transfer data from the Data
source.
Step 3: Once the IPOE-165 detects the existence of an IEEE 802.3at/
af device or Ethernet device, the LAN LED indicator will be lit
steadily, showing it is providing power.
Note
According to IEEE 802.3at/af standard, the IPOE-165
will not inject power to the cable if not connected to a
standard IEEE 802.3at/af device.
ESD Protection
Air 8KV DC
Contact 6KV DC
Surge Protection 6KV
Enclosure IP67-rated and IK10 aluminum metal case
Installation Wall-mount ear
Dimensions (W x D x H)
150 x 43.8 x 72.94 mm
169.85 x 43.8 x 72.94 mm, with cable
gland
Weight
339g
373g (with three waterproof cable glands)
MTBF >100000 hours
Power over Ethernet
PoE Standard
IEEE 802.3at Power over Ethernet Plus/
End-span PSE
Backward compatible with IEEE 802.3af
Power over Ethernet
PoE Power Output 54V DC, max. 30 watts
PoE Power Supply Type End-span
Power Pin Assignment 1/2 (+), 3/6 (-)