User's Manual

- 9 -
- 10 -
- 11 -
- 12 - - 13 - - 14 -
Hint
Please check the power requirements of
the device carefully, that is going to get the
power from IPOE-162S.
1. If the power requirement is higher
than the IPOE-162S can supply, current
overload might shut down the IPOE-162S
itself. Thus, it will also shut down your
device as well.
2. Please ensure the output voltage is
correct for remote device. Otherwise, it
will damage your remote device.
3. Forbid to switch on/off the Power DIP during
operation. Otherwise, it will damage your
IPOE-162S and remote device. If you
want to switch the output Voltage DIP,
please Plug OFF the “POE In” cable and
wait for 3 seconds until the POE LED
(Power) is completely OFF.
6-3 Wiring the Power Outputs
Please follow the steps below to insert the power wires.
Step 1: Please nd one terminal block connector within
two DC power outputs shown below:
1 V-
DC Output 1
DC Output 2
2 V-
3 V+
4 V+
Note
The wire gauge for the terminal block
should be in the range of 12 ~ 24 AWG.
Step 2: Insert the Negative / Positive DC wires into the
V– / V+ terminal; terminals 1 and 3 for Power
1; terminals 2 and 4 for Power 2.
6-2 4-pin Power Output Terminal Block
From top to down, there are Negative (V-), Negative
(V-), Positive (V+) and Positive (V+), and two sets of
DC power output contact.
Figure 3: DC Power Output Terminal Block Outlook
Note
Two DC outputs are sharing 12V 2A or 24V
1A, totaling 25W PoE output power, which
means that DC1 + DC2 cannot be over the
25W PoE output power. Otherwise, it might
cause the power output to malfunction or
damage.
Step 3: Connect the other point of DC power wires
to the power devices. Tighten the wire-clamp
screws for preventing the wires from loosening.
Maximum Output 25 Watts
Powered
Device
1
One Powered Device
Total Maximum
Output 25 Watts
Powered
Device
Powered
Device
1
2
Two Powered Device
Step 4: Install the terminal block on PLANET IPOE-
162S Splitter.
Step 5: Connect the network copper cable (RJ-45)
from the High Power Injector (PSE) and it will
provide power to PLANET IPOE-162S Splitter
and the IPOE-162S will separate the power
and data to the PDs (power devices). Please
see the Figure below:
Non-PoE
Device
802.3at
PSE
802.3at PoE+ Data in
Data Out
DC
-
DC+
10/100/1000T Copper
Customer Support
Thank you for purchasing PLANET products. You can
browse our online FAQ resource on PLANET Web site
rst to check if it could solve your issue. If you need
more support information, please contact PLANET switch
support team.
PLANET online FAQ :
http://www.planet.com.tw/en/support/faq.php?type=2
Switch support team mail address :
[e-mail]
Copyright © PLANET Technology Corp. 2014.
Contents are subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology Corp. All
other trademarks belong to their respective owners.