User's Manual
IP-based 4/8-port Switched Power Manager Power
IPM-4220 / IPM-8220
- 49 -
4.3.4 SNMP
You can set up SNMP Agent and SNMP Trap on this page.
Parameters Description
SNMP v1/v2 Enable
Enable SNMP v1/v2.
SNMP Port Set the destination port. Default is 161.
Read Community Key-in passwords in the Community Name field. Default is public.
SNMP Writing
Select the checkbox to enable SNMP Write-in.
Write Community Key-in passwords in the Community Name field. Default is private.
Parameters Description
SNMP v3 Enable
Enable SNMP v3.
User Name
The name is SNMP v3 command.
Type There are two types: Read Only, Read and Write.
Authorization Type There are two types: MD5 and SHA.
Authorization
Password
The password of authorization type. Use MD5 or SHA.
Private Type There are two types: No and DES.