Quick Guide

– 1 –
– 3 –
– 2 –
– 4 –
6 7 8 109 11 12 13
Transmitter (IHD-410PT)
1 2 3 4 5
6 7 8 10 11 12 14
Receiver (IHD-410PR)
Position Description Function
1
Ethernet
(PoE)
 Connect to a LAN Switch.
IGMP snooping and Jumbo Frame
supported Gigabit IEEE 802.3af/at PoE+
Ethernet switch is recommended.
 LED:
1. LAN LED (green color):
This LED will be ashing while network is
accessing via Ethernet.
2. Power LED (orange color):
When the device is powered on, and the
device is connected to Ethernet switch, the
LED will be always on.
Verify The Contents Inside Package Box
The package should contain the following items plus IHD-410 series. If
any item is missing or damaged, please contact the seller immediately.
Quick Installation Guide
IR Emitter Cable
(Comes with Transmitter)
IR Receiver Cable
(Comes with Receiver)
Mounting Bracket Screws
Product Outlook & Functions
1 2 3 4 5
Position Description Function
2 HDMI
Transmitter: HDMI Type-A female connector
for connecting to the HDMI source.
Receiver: HDMI Type-A female connector for
video output.
3 Audio In
3.5mm jack for connecting an external active
microphone.
4 Audio Out
3.5mm jack for connecting an active loud
speaker.
5 DC 12V
12V/2A DC power input.
Only use one power source, either from DC or
from 802.3af/at PoE+ Ethernet switch.
6 ACT/Link
 ACT: ACT LED indicator turns blue when
the device is powered up.
 Link: Link LED indicator ickers green
when network connection is waiting for
video source, turns green when network
connection and video source is functioning
properly.
7 RS-232
DB-9 female connector for RS-232
bi-directional remote extension.
8 IR
Transmitter: 3.5mm jack for IR emitter cable
to control video source device.
Receiver: 3.5mm jack for IR receiver cable to
receive signal from remote controller.
9 PC USB USB Host Input Port.
10 Group
Group conguration, 4-bit switch for 16
stream channel selection.
11 Reset
This button supports two functions: “Restore
to factory default setting” and “Stop
connecting to video source”.
Position Description Function
11 Reset
 Restore to factory default setting:
1. Turn on the device rst.
2. Press and hold the button for over 15
seconds. Once the device is operational
again, it has restored to default settings.
 Stop connecting to video source:
1. Turn on the device rst.
2. Press and hold the button for 1 second,
the link LED will turn off, the device does
not connect to video source.
3. Press and hold the button for 1 second
again, the link LED will turn on, the device
will connect to video source again.
12 G/V Mode
Press the button for 1 second to select
Graphic Mode or Video Mode (also deploy
to all the IHD-410PT and IHD-410PR of the
same channel).
13 VGA Out DB9 connector for VGA local display.
14 USB
USB ports for additional USB devices such
as USB mouse, USB keyboard and USB pen
drive.
Installation
1. Connect the video source to the Transmitter/Sender (IHD-410PT)
Unit’s HDMI In interface.
2. Connect the monitor to the Receiver (IHD-410PR) Unit’s HDMI Out
interface.
3. Set an identical ID number on DIP switch for all units of the same
group.