IHD-410-Series User Manual

Video Wall Ultra 4K HDMI/USB Extender over IP with PoE
IHD-410PT / IHD-410PR
51
As for Test B, we set port1 and port3 to a VLAN, and the Rx will convert the source if we issue the
command via telnet to set port2 and port3 to a VLAN.
3. You also could use HDMI splitter (matrix) to convert the source.
As you see, two sources connect to the input of HDMI matrix, and output to Tx, and then Tx and Rx all
connect to the switch.
In this case, we use the HDMI matrix controller to select the source.
Q6: Users encounter no screen display in computer connection.
A:
1. Make sure the device cables are correctly and firmly attached.
2. Set your display device’s (TV, monitor, etc.) input source as HDMI.
3. Check the PC BIOS configuration about the video output setting.
4. Connect VGA monitor to the Tx's VGA output port to check if the video signal gets through.
5. Slide the DIP Switch to the correct position.
6. Please reboot or disconnect and connect again.
Q7: Why can’t the Bonjour Browser find IHD-410PT or IHD-410PR?
A:
Please check the following:
1. The PC installed Bonjour Browser is not in the same LAN as IHD-410PT or IHD-410PR.
2. The IP address of PC might be in a different subnet from IHD-410PT/IHD-410PR. Please set the
PC’s IP address in the same subnet as IHD-410PT/IHD-410PR.
Q8: What’s the maximum limit distance between input video source and output video?
A:
The distance from the Tx to PoE switch and the distance from the Rx to PoE switch are both 100
meters. So the maximum distance between Tx and Rx is 200 meters.
Q9: What’s the maximum Rx units that can be linked via one Tx unit?
A:
Video Wall: 8 x 16.
Video Extender: Theoretically, 1000 are the most, as long as each Rx unit is assigned to an IP from
65534 IP.