IHD-410-Series User Manual

Video Wall Ultra 4K HDMI/USB Extender over IP with PoE
IHD-410PT / IHD-410PR
20
Chapter 3. Preparation
Before getting into the unit’s web UI, user has to find out the device’s IP address and configure PC’s
IP address.
3.1 Find the IP Address via Monitor
User is able to find the device’s IP address via monitor. Please refer to the steps below:
1. Connect HDMI monitor to the Receiver (IHD-410PR) unit’s HDMI Out interface.
2. Set an identical ID number on DIP switch for all units of the same group.
3. Use Cat5e/6 cables (EIA/TIA 568B industry standard compliant) for connection between
Transmitter/Receiver and the IEEE 802.3af/at PoE+ switch.
4. Apply the proper power to the Transmitter, Receiver, switch and monitor.
5. The monitor will show the information shown below.
Description
Function
FW
Show the date of firmware.
Local IP
Show the IHD-410PR’s IP address.
Remote IP
Show the connected IHD-410PT’s IP address.
ID
Show the IHD-410PR’s MAC address.