IHD-410-Series User Manual

Video Wall Ultra 4K HDMI/USB Extender over IP with PoE
IHD-410PT / IHD-410PR
19
Chapter 2. Hardware Installation
2.1 Devices Requirements
1. Monitor: HDCP compliant monitors with HDMI interface for the HDCP video source.
2. Ethernet cable: Cat5/5e/6 UTP cable (EIA / TIA 568B industry standard compliant).
3. PoE Switch: Please see the recommended PoE switch.
4. PC OS: Windows XP/7/8.1/10.
Application
Recommended Ethernet Switch
Video Wall/Video Extend
Application
Gigabit PoE Switch with IGMP snooping function and
jumbo frame function.
Multiple Video Wall Application
10 Gigabit PoE Switch with IGMP snooping function,
jumbo frame function and VLAN function.
The quality of the output signal will depend largely upon the quality of video source, cable
and display device used. Low-quality cables degrade output signal causing elevated noise
levels. Please use the proper cable and make sure the display device is capable of handling
the resolution and refresh rate selected.
2.2 Installation Instructions
1. Connect the video source to the Transmitter (IHD-410PT) unit’s HDMI In interface.
2. Connect the monitor to the Receiver (IHD-410PR) unit’s HDMI Out interface.
3. Set an identical ID number on DIP switch for all units of the same group.
4. Connect the USB cables from Transmitter to PC, and connect the USB additional devices such as
USB mouse, USB keyboard and USB pen drive to Receiver.
5. Use Cat5e/6 cables (EIA/TIA 568B industry standard compliant) for connection between
Transmitter/Receiver and the IEEE 802.3af/at PoE+ switch.
6. Apply the proper power to all connecting devices.
7. Connect the IR emitter cable with Transmitter and the IR receiver cable with Receiver for remote
control (optional).
Ensure that all devices are powered off before connecting to the unit.
Make sure all devices connected are properly grounded.
Place cables away from fluorescent lights and air conditioners that are likely to generate
electrical noise.
Please allow adequate space around the unit for ventilation.