IHD-410-Series User Manual
Table Of Contents
Video Wall Ultra 4K HDMI/USB Extender over IP with PoE
IHD-410PT / IHD-410PR
16
Position
Description
Function
switch, the LED will be always on.
2
HDMI
Transmitter: HDMI Type-A female connector for connecting to the HDMI
source.
Receiver: HDMI Type-A female connector for video output.
3
Audio In
3.5mm jack for connecting an external active microphone.
4
Audio Out
3.5mm jack for connecting an active loud speaker.
5
DC 12V
12V/2A DC power input.
Only use one power source, either from DC or from 802.3af/at PoE+
Ethernet switch.
6
ACT/Link
ACT: ACT LED indicator turns blue when the device is powered up.
Link: Link LED indicator flickers green when network connection is
waiting for video source, and turns green when network connection and
video source are functioning properly.
7
RS232
DB-9 female connector for RS232 bi-directional remote extension.
8
IR
Transmitter: 3.5mm jack for IR emitter cable to control video source device.
Receiver: 3.5mm jack for IR receiver cable to receive signal from remote
controller.
9
PC USB
USB host input port.
10
Group
Group configuration, 4-bit switch for 16 stream channel selection.
11
Reset
This button supports two functions: “Restore to factory default setting” and
“stop connecting to video source”.
Restore to factory default setting:
1. Turn off the device first.
2. Press and hold the reset button, and then turn on the device. Keep
pressing the reset button until the ACT and Link LED flash.
3. Turn off the device and back on. Once the device is operational
again, it has restored to default settings.
Stop connecting to video source:
1. Turn on the device first.
2. Press and hold the reset button for 1 second; the link LED will turn
off; the device does not connect to video source.
3. Press and hold the reset button for 1 second again; the link LED will
turn on; the device will connect to video source again.
12
G/V Mode
Press the button for 1 second to select Graphic Mode or Video Mode (also
deploy to all the IHD-200PT and IHD-200PR of the same channel)
13
VGA Out
DB9 connector for VGA local display
14
USB
USB ports for additional USB devices such as USB mouse, USB keyboard
and USB pen drive.