IHD-210-Series User Manual

High Definition HDMI Extender over IP with PoE
IHD-210PT / IHD-210PR
30
Description
Function
Device IP
Show the selected device’s IP address.
Tx Version
Show the firmware version.
Encoder
Version
Show the Encoder version.
LAN Status
If the device connects to LAN successfully, it will show “Link Up”.
Video Lock
Lock: The video is transmitting.
Unlock: There is no transmitting video.
HDCP
If the transmitting video supports HDCP, it will show “on”.
If the transmitting video does not support HDCP, it will show “off”.
Down Scale
Setup
Setting the resolution downscale of each group on the selected Tx --
After changing the setting, please click the update button to make the change
effective.
Group ID
Setting the selected Tx group ID –
The maximum is up to 64 groups from 0 to 63. After changing the setting, please click
the update button to make the change effective.
After rebooting, the Group ID will follow the hardware Group setting.
UART Baud
Rate
Setting the baud rate of RS232 extension on the selected Tx --
After changing the setting, please click the update button to make the change
effective.
Note that the baud rate of Tx and Rx should be the same.
Stream Output
Path
Setting the selected Tx video output path --
1. Loopthrough and Network Output: The HDMI out port of Tx and Rx will output the
video.
2. Disable Network Output: Only the Tx’s HDMI out port will output the video.
3. Disable Loopthrough Output: Only the Rx’s HDMI out port will output the video.
4. Disable All Video Output: The HDMI out port of Tx and Rx will not output the video.
After changing the setting, please click the update button to make the change
effective.
MAC Address
Display the Ethernet MAC address of the device. Note that user cannot change it.
Device Name
Setting the selected Tx name for identification --
Up to 32 digits is accepted for the device name setting.
After changing the setting, please click the update button to make the change
effective.
If the Tx Device Selection can’t load device properly, please make sure the PC’s IP address
is in the same subnet as IHD-210PT.