Quick Guide

3. Wiring the Power Inputs

The Upper Panel of the Media Converter comes with one 6-contact

terminal block. Please follow the steps below to insert the power wire.

1. Insert positive/negative DC power wires into Contacts 1 and 2 for

Power 1, or Contacts 5 and 6 for Power 2.

IGT-900-1T1S and IGT-900-2T2S: DC 9-48V, AC 24V

Max. Fault Alarm Loading: 24V, 1A

DC Input: 9-48V

, 1A max.

AC Input: 24V

, 0.6A max.

V1+ V2+

PWR1

PWR2Alarm

1 2 3 4 5 6

Figure 3-1: IGT-900-1T1S/IGT-900-2T2S Upper Panel

2. Tighten the wire-clamp screws for preventing the wires from loos-

ening.

1 2 3 4 5 6

V+ V- V+ V-

Power 1 Power 2

Positive (+) Pin Negative (-) Pin

IGT-900-Series Pin 1/5 Pin 2/6

Caution

PWR1 and PWR2 must provide the same DC voltage

while operating with dual power input.