User Manual

2. Make sure both sides of the SFP transceiver are with the same

media type; for example, 1000BASE-SX to 1000BASE-SX,

1000BASE-LX to 1000BASE-LX.

3. Check whether the ber-optic cable type matches the SFP trans-

ceiver model.

 To connect to 1000BASE-SX SFP transceiver, use the multi-mode

ber cable with one side being the male duplex LC connector type.

 To connect to 1000BASE-LX SFP transceiver, use the single-mode

ber cable with one side being the male duplex LC connector type.

Connectingthebercable

1. Attach the duplex LC connector on the network cable to the SFP

transceiver.

2. Connect the other end of the cable to a device, switches with SFP

installed, to ber NIC on a workstation or a Media Converter.

3. Check the LNK/ACT LED of the SFP slot on the front of the Industrial

Gigabit Media Converter. Make sure that the SFP transceiver is oper-

ating correctly.

 100BASE-FX:

Before connecting the other switches, workstation or Media Converter,

please do the following:

1. On IGT-1205AT, set the DIP Switch of SFP Port 1 or Port 2 to the

“ON” position with ber speed “100FX”.

ON OFF

Port 1 (DIP 1) 100FX 1000X

Port 2 (DIP 2) 100FX 1000X

2. Make sure both sides of the SFP transceiver are with the same

media type or WDM pair; for example, 100BASE-FX to 100BASE-FX,

100BASE-BX20-U to 100BASE-BX20-D.

3. Check the ber-optic cable type match the SFP transceiver model.

 To connect to MFB-FX SFP transceiver, use the multi-mode ber

cable with one side being the male duplex LC connector type.

 To connect to MFB-F20/F40/F60/FA20/FB20 SFP transceiver, use

the single-mode ber cable with one side being the male duplex

LC connector type.