(V3) User Manual

Table Of Contents
User’s Manual of IGSW-24040T
2.3.1 Installing the SFP Transceiver
The sections describe how to insert an SFP transceiver into an SFP slot. The SFP transceivers are hot-pluggable and
hot-swappable. You can plug in and out the transceiver to/from any SFP port without having to power down the Industrial
Managed Switch, as the Figure 2-3-1 shows:
Follow all the SFP installation steps as shown in the example.
Figure 2-3-1: Plugging in the SFP Transceiver
Approved PLANET SFP Transceivers
PLANET Industrial Managed Switch supports both single mode and multi-mode SFP transceivers. The following list of
approved PLANET SFP transceivers is correct at the time of publication:
Fast Ethernet Transceiver (100BASE-X SFP)
Model Speed (Mbps) Connector Interface
Fiber Mode
Distance
Wavelength (nm) Operating Temp.
MFB-FX 100 LC Multi Mode 2km 1310nm 0 ~ 60 degrees C
MFB-F20 100 LC Single Mode
20km 1310nm 0 ~ 60 degrees C
MFB-F40 100 LC Single Mode
40km 1310nm 0 ~ 60 degrees C
MFB-F60 100 LC Single Mode
60km 1310nm 0 ~ 60 degrees C
MFB-F120 100 LC Single Mode
120km 1550nm 0 ~ 60 degrees C
MFB-TFX 100 LC Multi Mode 2km 1310nm -40 ~ 75 degrees C
MFB-TF20 100 LC Single Mode
20km 1550nm -40 ~ 75 degrees C
36