User's Manual

Step 3: Check whether the DIN-Rail is tightly on the track.

Step 4: Please refer to following procedures to remove the Industrial

Gigabit Ethernet Switch from the track.

Step 5: Lightly pull out the bottom of DIN-Rail to remove it from the

track.

2.2.2 Wall Mount Plate Mounting

To install the Industrial Gigabit Ethernet Switch on the wall, please

follow the instructions described below.

Step 1: Remove the DIN-Rail from the Industrial Gigabit Ethernet

Switch; loose the screws to remove the DIN-Rail.

Step 2: Place the wall mount plate on the rear panel of the Industrial

Gigabit Ethernet Switch.