User's Manual

2.1.5 Wiring the Power Inputs

The 6-contact terminal block connector on the top panel of Industrial

Gigabit Ethernet Switch is used for two DC redundant powers input.

Please follow the steps below to insert the power wire.

1. Insert positive / negative DC power wires into contacts 1 and 2 for

POWER 1, or 5 and 6 for POWER 2.

DC12~48V, AC 24V

V1- V1 + V2 - V2 +

2. Tighten the wire-clamp screws for preventing the wires from loos-

ening.

1 2 3 4 5 6

Power 1 Fault Power 2

- + - +

Note

The wire gauge for the terminal block should be in the

range between 12 and 24 AWG.