User's Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 5. SWITCH OPERATION
- Appendix A—RJ-45 Pin Assignment
- Appendix B Troubles shooting
- APPENDEX C : GLOSSARY
- EC Declaration of Conformity
User’s Manual of IGS-801M
Figure 4-6-5 RSTP Port Configuration
The page includes the following fields:
Object Description
Port
Indicate port 1 to port 24.
Edge
Indicates whether the port is enabled as an edge port.
Edge port cannot create loops, but it loses edge port status if a topology change
creates a potential for a loop. An edge port normally should not receive BPDU
packets. If a BPDU packet is received it automatically loses edge port status.
Path Cost
The port contribution to the root path cost. The path cost is adjusted to a higher or
Value Rage : 1-20000000.
cally set by the
port speed and the default path cost method. The default values for path costs
are:
- Ethernet – 2000000.
- 200000.
lower value, and is used to forward traffic when a path being rerouted.
Default Path Cost -- The default path cost of the port is automati
- Fast Ethernet
- Gigabit Ethernet - 20000.
76