User's Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 5. SWITCH OPERATION
- Appendix A—RJ-45 Pin Assignment
- Appendix B Troubles shooting
- APPENDEX C : GLOSSARY
- EC Declaration of Conformity
User’s Manual of IGS-801M
2.2.3 Wall Mount Plate Mounting
To install the Industrial Gigabit Ethernet Switch on the wall, please follows the instructions described below.
Step 1: Remove the DIN-Rail from the Industrial Gigabit Ethernet Switch; loose the screws to remove the DIN-Rail.
Step 2: Place the wall mount plate on the rear panel of the Industrial Gigabit Ethernet Switch.
Step 3: Use the screws to screw the wall mount plate on the Industrial Gigabit Ethernet Switch.
hernet Switch on the
Step 5: ove the wall mount plate, reverse steps above.
2.2.4 Wiring the Power Inputs
anel of IGS-801M is used for two DC redundant power input. Please
. Insert positive / negative DC power wires into the contacts 1 and 2 for POWER 1, or 5 and 6 for POWER 2.
Step 4: Use the hook holes at the corners of the wall mount plate to hang the Industrial Gigabit Et
wall.
To rem
The 6-contact terminal block connector on the top p
follow the steps below to insert the power wire.
1
2.
Figure 2-5 Wiring the redundant power inputs
18