User's Manual

Table Of Contents
User’s Manual of IGS-801M
Step 2: Place the bottom of DIN-rail lightly into the track.
Step 3: Check whether the DIN-rail is tightly on the track.
Step 4: Please refer to the following procedures to remove the Industrial Managed Switch from the track.
Step 5: Lightly pull out the bottom of DIN-rail to remove it from the track.
2.2.2 Wall-mount Plate Mounting
To install the Industrial Managed Switch on the wall, please follow the instructions described below.
Step 1: Remove the DIN-rail from the Industrial Managed Switch; loosen the screws to remove the
DIN-rail.
25