Datasheet

3
IGS-6329-8UP2S2X
• Port mirroring to monitor the incoming or outgoing trafc on a
particular port
• Loop protection to avoid broadcast loops
• Link Layer Discovery Protocol (LLDP)
• Compatible with Cisco uni-directional link detection(UDLD)
that monitors a link between two switches and blocks the
ports on both ends of the link if the link fails at any point
between the two devices
• Supports G.8032 ERPS (Ethernet Ring Protection Switching)
• IEEE 1588v2 PTP (Precision Time Protocol) transparent clock
mode
Quality of Service
• Ingress Shaper and Egress Rate Limit per port bandwidth
control
• 8 priority queues on all switch ports
• Trafc classication
– IEEE 802.1p CoS
– IP TOS/DSCP/IP precedence
– IP TCP/UDP port number
– Typical network application
• Strict priority and Weighted Round Robin (WRR) CoS policies
• Supports QoS and In/Out bandwidth control on each port
• Trafc-policing on the switch port
• DSCP remarking
Multicast
• Supports IPv4 IGMP snooping v1, v2 and v3
• Supports IPv6 MLD snooping v1 and v2
• Querier mode support
• IPv4 IGMP snooping port ltering
• IPv6 MLD snooping port ltering
• MVR (Multicast VLAN Registration)
Security
• Authentication
– IEEE 802.1X Port-based/MAC-based network access
authentication
– Built-in RADIUS client to cooperate with the RADIUS
servers
– TACACS+ login users access authentication
– RADIUS/TACACS+ users access authentication
– Guest VLAN assigns clients to a restricted VLAN with
limited services.
• Access Control Lit
PoE Schedule for Energy Savings
Under the trend of energy savings worldwide and contributing to environmental
protection on the Earth, the IGS-6329 PoE++ Series can effectively control the
power supply besides its capability of giving high watts power. The built-in “PoE
schedule” function helps you to enable or disable PoE power feeding for each
PoE port during specied time intervals and it is a powerful function to help SMBs
or enterprises save power and money.
PoE
1000BASE-T UTP with PoE
6 Watts 6 Watts 12 Watts 12 Watts
Total Consumption of 36 watts/hr
PoE
PoE PoE
PoE
Power
On
Power
On
Power
On
Power
On
5 PM8 AM
5 PM 8 AM
6 Watts 6 Watts 12 Watts 12 Watts
Save 24 watts/hr during off-business hours
PoE PoE
Total Saved = 10800 watts/month
PoE PoE
Power
On
Power
Off
Power
Off
Power
Off
Scheduled Power Recycling
The IGS-6329 PoE++ Series allows each of the connected PoE IP cameras or
PoE wireless access points to reboot at a specic time each week. Therefore, it will
reduce the chance of IP camera or AP crash resulting from buffer overow.
IP Camera
S M T W T F S
AP Router IP Phone
PoE lighting
Door Phone
Automatically Reboot
Layer 3 Routing Support
The IGS-6329 Series enables the administrator to conveniently boost network
efficiency by configuring Layer 3 IPv4/IPv6 VLAN static routing manually, the
RIP(Routing Information Protocol) or OSPF (Open Shortest Path First) settings
automatically. The RIP can employ the hop count as a routing metric and prevent
routing loops by implementing a limit on the number of hops allowed in a path
from the source to a destination. The OSPF is an interior dynamic routing protocol
for autonomous system based on link state. The protocol creates a database for
link state by exchanging link states among Layer 3 switches, and then uses the
Shortest Path First algorithm to generate a route table based on that database.