User's Manual

User’s Manual of IGS-604HPT-M12
346
 Master Only - clock's Device Type is Master Only.
 Slave Only - clock's Device Type is Slave Only
Static member:
defined by the system, true if two-step Sync events and
Pdelay_Resp events are used.
 2 Step Flag
It sh
ows unique clock identifier.
 Clock Identity
If true, one-
way measurements are used. This parameter applies only to a slave.
In one-way mode no delay measurements are performed, i.e. this is applicable
only if frequency synchronization is needed. The master always responds to
delay requests.
 One Way
T
ransport protocol used by the PTP protocol engine
ethernet PTP over Ethernet multicast
ip4multi PTP over IPv4 multicast
ip4uni PTP over IPv4 unicast
Note : IPv4 unicast protocol only works in Master only and Slave only clocks
See parameter Device Type
In a unicast Slave only clock you also need configure which master clocks
to request Announce and Sync messages from. See: Unicast Slave configuration
 Protocol
Enab
les the VLAN tagging for the PTP frames.
Note: Packets are only tagged if the port is configured for vlan tagging.
i.e:
Port Type != Unaware and PortVLAN mode == None, and the port is member of
the VLAN.
 VLAN Tag Enable
VLAN Identifi
er used for tagging the PTP frames.
 VID
Priorit
y Code Point value used for PTP frames.
 PCP
Buttons
: Click to create a new clock instance.
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
Local Clock Current Time
Object Description
Sho
ws the actual PTP time with nanosecond resolution.
 PTP Time
 Clock Adjustment
Method
Shows the actual clock adjustment method. The method depends on the
available hardware.