Datasheet
IGS-5227X-4P2T
10
Specications
Product
IGS-5227X-4P2T
HardwareSpecications
Copper Ports 6 x M12, 8-pin X-coded female connector, 10/100/1000BASE-T auto-MDI/MDI-X ports
Power Connector 1 x M23, 5-pin A-coded male connector
Dimensions (W x D x H) 103 x 68.2 x 163 mm
Weight 1151g
Enclosure IP67 aluminum case
Installation Wall-mount kit and DIN-rail kit
Power Consumption
ystem on:
DC 12V:6.7W/22BTU
DC 18V:6.3W/21BTU
DC 56V:6.7W/22BTU
Full Loading:
DC 12V:72W/245BTU
DC 18V:98W/334BTU
DC 56V:136W/464BTU
Power Requirements Dual 12~56V DC
ESD Protection 6KV DC
LED
System:
PWR1 (Green), PWR2 (Green), Fault (Red)
Ring (Green), R.O. (Green)
10/100/1000T RJ45 Interfaces :
LNK/ACT (Green)
PoE-in-Use (Orange) (Port 3 to port 6)
SwitchingSpecications
Switch Architecture Store-and-Forward
Switch Fabric 12Gbps/non-blocking
Throughput 8.9Mpps@64bytes
Address Table 8K entries, automatic source address learning and aging
Shared Data Buffer 4M bits
Flow Control
IEEE 802.3x pause frame for full duplex
Back pressure for half duplex
Jumbo Frame 9K bytes
Power over Ethernet
PoE Standard IEEE 802.3at/802.3af PoE/PSE
PoE Power Supply Type End-span
Power Pin Assignment 1/2(+), 3/6(-)
PoE Power Output
Per port 54V DC, 350mA; max. 15.4 watts (IEEE 802.3af)
Per port 54V DC, 590mA; max. 36 watts (IEEE 802.3at)
PoE Power Budget
144W@48~56V DC input
90W@18~47V DC input
60W@12~17V DC input
PoE Ability
PD @ 7 watts: 4 units
PD @ 15.4 watts: 4 units
PD @ 30.8 watts: 4 units
Layer 2 Management Functions
PortConguration
Port disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow control disable/enable
Power saving mode control
Port Status Displayeachport’sspeedduplexmode,linkstatus,owcontrolstatus,autonegotiationstatus,trunkstatus
Port Mirroring
TX/RX/Both
Many-to-1 monitor
VLAN
802.1Q tag-based VLAN, up to 4K VLAN groups
Q-in-Q tunneling
Private VLAN Edge (PVE)
MAC-based VLAN
Protocol-based VLAN
VLAN Translation
Voice VLAN
MVR (Multicast VLAN Registration)
GVRP
Up to 4K VLAN groups, out of 4094 VLAN IDs