User's Manual

Table Of Contents
Users Manual of IGS-5227-Series
18
1.5 Product Specifications
Product IGS-5227-6T IGS-5227-6MT IGS-5227-6MT-X
Hardware Specifications
Copper Ports
6 waterproof and dustproof
RJ45
10/100/1000BASE-T
auto-MD
I/MDI-X ports
6 M12, 8-pin A-Coded female
connector,
10/100/1000BASE-T
auto-MDI/MDI-X ports
6 M12, 8-pin X-Coded female
connector,
10/100/1000BASE-T
auto-MDI/MDI-X ports
Switch Architecture
Store-and-Forward
Switch Fabric
12Gbps/non-blocking
Throughput
8.9Mpps@64bytes
Address Table
8K entries, automatic source address learning and aging
Shared Data Buffer
4M bits
Flow Control
IEEE 802.3x pause frame for full-duplex
Back pressure for half-duplex
Jumbo Frame
9K bytes
Reset Button
< 5 sec: System reboot
> 5 sec: Factory default
Dimensions (W x D x
H)
103 x 68.3 x 163 mm
Weight
1069g 1069g 1037g
LED
System:
DC1 (Green), DC2 (Green), Fault (Red)
Ring (Green), R.O. (Green)
10/100/1000T RJ45 Interfaces
LNK/ACT (Green
Power Consumption
Max. 8.3 watts/ 28.5 BTU
Power Requirements
Dual 9~48V DC, 24V AC
ESD Protection
6KV DC
Layer 2 Management Functions
Port Configuration
Port disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow control disable/enable
Port Status
Display each port’s speed duplex mode, link status, flow control status,
auto-negotiation status, trunk status
Port Mirroring
TX/RX/Both
Many-to-1 monitor
VLAN
802.1Q tagged based VLAN
Q-in-Q tunneling
Private VLAN Edge (PVE)
MAC-based VLAN
Protocol-based VLAN
Voice VLAN
IP Subnet-based VLAN
MVR (Multicast VLAN registration)
Up to 255 VLAN groups, out of 4095 VLAN IDs
Link Aggregation IEEE 802.3ad LACP/static trunk