(V3) Datasheet

3
IGS-5225-8P2S2X
• Link Layer Discovery Protocol (LLDP)
Layer 3 IP Routing Features
• Supports maximum 128 static routes and route summarization
• IPv4 dynamic routing protocol supports OSPFv2
• IPv4/IPv6 hardware static routing
• Routing interface provides per VLAN routing mode
Quality of Service
• Ingress Shaper and Egress Rate Limit per port bandwidth
control
• 8 priority queues on all switch ports
• Trafc classication
– IEEE 802.1p CoS
– TOS/DSCP/IP precedence of IPv4/IPv6 packets
– IP TCP/UDP port number
– Typical network application
• Strict priority and Weighted Round Robin (WRR) CoS policies
• Supports QoS and In/Out bandwidth control on each port
• Trafc-policing policies on the switch port
• DSCP remarking
Multicast
• Supports IGMP snooping v1, v2 and v3
• Supports MLD snooping v1 and v2
• Querier mode support
• IGMP snooping port ltering
• MLD snooping port ltering
• Multicast VLAN Registration (MVR) support
Security
• Authentication
– IEEE 802.1x Port-based / MAC-based network access
authentication
– Built-in RADIUS client to co-operate with the RADIUS
servers
– TACACS+ login users access authentication
– RADIUS / TACACS+ users access authentication
• Access Control List
– IP-based Access Control List (ACL)
– MAC-based Access Control List
• Source MAC / IP address binding
• DHCP Snooping to lter un-trusted DHCP messages
• Dynamic ARP Inspection discards ARP packets with invalid
MAC address to IP address binding
PoE Schedule for Energy Saving
Under the trend of energy saving worldwide and contributing to environmental
protection on the Earth, the IGS-5225-8P2S2X can effectively control the power
supply besides its capability of giving high watts power. The built-in “PoE
schedule” function helps you to enable or disable PoE power feeding for each
PoE port during specied time intervals and it is a powerful function to help SMBs
or enterprises save power and money.
PT PoE Camera
Ping Request
Ping Request
Check alive status for 3 times
Restart PoE device if without response
Ping Echo
No Response......
PD Alive!!
Step 1
Step 3
Step 2
Step 4
ON
PoE
ON
ON
PoE
OFF
PD Status
Good!!
Alarm Notification
PoE
1000BASE-TX UTP with PoE
6 Watts 6 Watts 12 Watts 12 Watts
Total Consumption of 36 watts/hr
PoE
PoE PoE
PoE
Power
On
Power
On
Power
On
Power
On
5 PM8 AM
5 PM 8 AM
6 Watts 6 Watts 12 Watts 12 Watts
Save 24 watts / hr during off-business hours
PoE PoE
Total Saved = 10800watts / month
PoE PoE
Power
On
Power
Off
Power
Off
Power
Off
Scheduled Power Recycling
The IGS-5225-8P2S2X allows each of the connected PoE IP cameras or PoE
wireless access points to reboot at a specific time each week. Therefore, it will
reduce the chance of IP camera or AP crash resulting from buffer overow.
S M T W T F S
Automatically Reboot
Every Friday 23:00
PoE PT Camera
ON ON
PoE
OFF
CPU/Buffer
Load 85%
CPU/Buffer
Load 10%