User's Manual

User’s Manual of IGS-5225 series
157
• Speed
Display the speed of current SFP module; the speed value or description is got
from the SFP module. Different vendors SFP modules might show different
speed information.
• Wave Length (nm)
Display the wavelength of current SFP module; the wavelength value is got from
the SFP module. U
se this column to check if the wavelength values of two nodes
are matched while the fiber connection failed.
• Distance (m)
Display the support distance of current SFP module; the distance value is got
from the SFP module.
• Temperature (C)
– SFP DDM Module Only
Display the temperature of current SFP DDM module; the temperature value is
got from the SFP DDM module.
• Voltage(V)
– SFP DDM Module Only
Display the voltage of current SFP DDM module; the voltage value is got from the
SFP DDM module.
• Current(mA)
– SFP DDM Module Only
Display the Ampere of current SFP DDM module; the Ampere value is got from
the SFP DDM module.
• TX power (dBm)
– SFP DDM Module Only
Display the TX power of current SFP DDM module; the TX power value is got
from the SFP DDM module.
• RX power (dBm)
– SFP DDM Module Only
Display the RX power of current SFP DDM module; the RX power value is got
from the SFP DDM module.
Buttons
SFP Monitor Event Alert:
send trap
Warning Temperature:
degrees C
Check SFP Monitor Event Alert box; it will be in accordance with your warning temperature setting and allows users to
record message out via SNMP Trap.
Auto-refresh
: Check this box to enable an automatic refresh of the page at regular intervals.
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
: Click to refresh the page immediately.