User Manual

Table Of Contents
Users Manual of IGS-5225 series
44
2. Tighten the wire-clamp screws for preventing the wires from loosening.
1 2 3 4 5 6
DI0 DI1 DO0 DO1 GND GND
Figure 2-8 6-pin Terminal Block for DI and DO Wiring Input
3. There are two Digital Input groups for you to monitor two different devices. The following topology shows how to wire DI0
and DI1.
Figure 2-9 Wires DI0 and DI1 to Open Detector
4. There are two Digital Output groups for you to sense IGS-5225-4UP1T2S/IGS-5225-8P2T2S port failure or power failure
and issue a high or low signal to external device. The following topology shows how to wire DO0 and DO1.