Datasheet

7
IGS-5225-4P2S
Specications
Product
IGS-5225-4P2S
HardwareSpecications
Copper Ports 4 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports
SFP/mini-GBIC Slots
2 1000BASE-SX/LX/BX SFP interfaces (Port-5 to Port-6)
Compatible with 100BASE-FX SFP
PoE Injector Port 4 ports with 802.3at/af PoE injector function with Port-1 to Port-8
Console 1 x RJ45-to-RS232 serial port (115200, 8, N, 1)
Switch Architecture Store-and-Forward
Switch Fabric 12Gbps/non-blocking
Throughput (packet per second) 8.928Mpps@ 64 bytes packet
Address Table 8K entries, automatic source address learning and aging
Shared Data Buffer 4Mbits
Flow Control
IEEE 802.3x pause frame for full duplex
Back pressure for half duplex
Jumbo Frame 9Kbytes
Reset Button
<5 sec: System reboot
>5 sec: Factory default
ESD Protection 6KV DC
Enclosure IP40 metal case
Installation DIN-rail kit and wall-mount kit
Connector
Removable 6-pin terminal block for power input
Pin 1/2 for Power 1, Pin 3/4 for fault alarm, Pin 5/6 for Power 2
Alarm One relay output for power failure. Alarm relay current carry ability: 1A @ 24V DC
LED Indicator
System:
Power 1 (Green)
Power 2 (Green)
Fault Alarm (Red)
Ring (Green)
Ring Owner (Green)
Per 10/100/1000T RJ45 PoE+ Ports:
PoE-in-Use (Orange)
LNK/ACT (Green)
Per SFP Interface:
100 LNK/ACT (Orange)
1000 LNK/ACT (Green)
Dimensions (W x D x H) 50 x 87.8 x 135
Weight 610g
Power Requirements Dual 48~56V DC (>51V DC for PoE+ output recommended)
Power Consumption
Max. 6.2 watts/26.76BTU (Power on without any connection)
Max. 151.8 watts/520.82BTU (Full loading with PoE function)
Power Over Ethernet
PoE Standard IEEE 802.3at Power over Ethernet Plus/PSE
PoE Power Supply Type End-span
PoE Power Output
IEEE 802.3af Standard
- Per port 48V~51V DC (depending on the power supply), max. 15.4 watts
IEEE 802.3at Standard
- Per port 51V~56V DC (depending on the power supply), max. 36 watts
Power Pin Assignment 1/2(+), 3/6(-)
PoE Power Budget Dual power input: 144W maximum (depending on power input)
Max. Number of Class 2 PDs 4
Max. Number of Class 3 PDs 4
Max. Number of Class 4 PDs 4
Layer 2 Function
Basic Management Interfaces Console;Telnet;Webbrowser;SNMPv1,v2c
Secure Management Interfaces SSH, SSL, SNMP v3
PortConguration
Port disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow control disable/enable
Power saving mode control
Port Status Displayeachport’sspeedduplexmode,linkstatus,owcontrolstatus,autonegotiationstatus,trunkstatus
Port Mirroring
TX/RX/both
1 to 1 monitor