Datasheet

7
IGS-5225-4P2S
Specications
Product
IGS-5225-4P2S
HardwareSpecications
Copper Ports 4 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports
SFP/mini-GBIC Slots
2 1000BASE-SX/LX/BX SFP interfaces (Port-5 to Port-6)
Compatible with 100BASE-FX SFP
PoE Injector Port 4 ports with 802.3at/af PoE injector function with Port-1 to Port-8
Console 1 x RJ45-to-RS232 serial port (115200, 8, N, 1)
Switch Architecture Store-and-Forward
Switch Fabric 12Gbps/non-blocking
Throughput (packet per second) 8.928Mpps@ 64 bytes packet
Address Table 8K entries, automatic source address learning and aging
SharedDataBu󰀨er 4Mbits
Flow Control
IEEE 802.3x pause frame for full duplex
Back pressure for half duplex
Jumbo Frame 9Kbytes
Reset Button
<5 sec: System reboot
>5 sec: Factory default
ESD Protection 6KV DC
Enclosure IP40 metal case
Installation DIN-rail kit and wall-mount kit
Connector
Removable 6-pin terminal block for power input
Pin 1/2 for Power 1, Pin 3/4 for fault alarm, Pin 5/6 for Power 2
Alarm One relay output for power failure. Alarm relay current carry ability: 1A @ 24V DC
LED Indicator
System:
Power 1 (Green)
Power 2 (Green)
Fault Alarm (Red)
Ring (Green)
Ring Owner (Green)
Per 10/100/1000T RJ45 PoE+ Ports:
PoE-in-Use (Orange)
LNK/ACT (Green)
Per SFP Interface:
100 LNK/ACT (Orange)
1000 LNK/ACT (Green)
Dimensions (W x D x H) 50 x 87.8 x 135
Weight 610g
Power Requirements Dual 48~56V DC (>51V DC for PoE+ output recommended)
Power Consumption
Max. 6.2 watts/26.76BTU (Power on without any connection)
Max. 151.8 watts/520.82BTU (Full loading with PoE function)
Power Over Ethernet
PoE Standard IEEE 802.3at Power over Ethernet Plus/PSE
PoE Power Supply Type End-span
PoE Power Output
IEEE 802.3af Standard
- Per port 48V~51V DC (depending on the power supply), max. 15.4 watts
IEEE 802.3at Standard
- Per port 51V~56V DC (depending on the power supply), max. 36 watts
Power Pin Assignment 1/2(+), 3/6(-)
PoE Power Budget Dual power input: 144W maximum (depending on power input)
Max. Number of Class 2 PDs 4
Max. Number of Class 3 PDs 4
Max. Number of Class 4 PDs 4
Layer 2 Function
Basic Management Interfaces Console; Telnet; Web browser; SNMP v1, v2c
Secure Management Interfaces SSH, SSL, SNMP v3
PortConguration
Port disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow control disable/enable
Power saving mode control
Port Status Displayeachport’sspeedduplexmode,linkstatus,owcontrolstatus,autonegotiationstatus,trunkstatus
Port Mirroring
TX/RX/both
1 to 1 monitor