User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.2.1 System Information
- 4.2.2 IP Configurations
- 4.2.3 IPv6 Configuration
- 4.2.4 User Configuration
- 4.2.5 Time Settings
- 4.2.6 Log Management
- 4.2.7 SNMP Management
- 4.2.8 RMON
- 4.2.9 Fault Alarm Configuration
- 4.2.10 Remote Management
- 4.3 Port Management
- 4.3.1 Port Configuration
- 4.3.2 Port Counters
- 4.3.3 Bandwidth Utilization
- 4.3.4 Port Mirroring
- 4.3.5 Jumbo Frame
- 4.3.6 Port Error Disabled Configuration
- 4.3.7 Port Error Disabled Status
- 4.3.8 Protected Ports
- 4.3.9 EEE
- 4.3.10 SFP Module Information
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN Setting Example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 IGMP Snooping
- 4.9 MLD Snooping
- 4.10 LLDP
- 4.11 MAC Address Table
- 4.12 Quality of Service
- 4.13 Security
- 4.14 Ring
- 4.15 Maintenance
- 4.16 Diagnostics
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of IGS-4215 series
236
4.12.4 Bandwidth Control
Configure the switch port rate limit for the switch port on this page.
4.12.4.1 Ingress Bandwidth Control
This page provides to select the ingress bandwidth preamble. The Ingress Bandwidth Control Setting and Status screens in
Figure 4-12-17 and Figure 4-12-18 appear.
Figure 4-12-17: Ingress Bandwidth Control Settings Page Screenshot
The page includes the following fields:
Object Description
• Port
Select port number from this drop-down list.
• State
Enable or disable the port rate policer. The default value is "Disabled".
• Rate (Kbps)
Configures the rate for the port policer. The default value is "unlimited". Valid
values are in the range 0 to 1000000.
Buttons
: Click to apply changes.
Figure 4-12-18: Ingress Bandwidth Control Status Page Screenshot